Reference prices
Actual quotations depend on inspection, location, access, materials, and unit condition.
| Service | Reference price | Notes |
|---|---|---|
| Window-type aircon — installation (standard) | ₱1,500 – ₱3,000 | Includes wall-cutting (if needed), mounting bracket, and basic electrical connection. Unit price not included. |
| Window-type aircon — installation (with wall cutting) | ₱2,500 – ₱5,000 | Concrete or hollow block wall cutting adds significant labor. Price varies by wall thickness. |
| Split-type aircon — standard installation (up to 3m pipe) | ₱3,000 – ₱6,000 | Includes copper pipe set, electrical wiring, drainage, and mounting. Up to 3 meters of pipe run included. |
| Split-type aircon — installation (4–7m pipe run) | ₱5,000 – ₱9,000 | Longer pipe runs require more copper piping, insulation, and labor. Common for back-to-back unit placement not possible. |
| Split-type aircon — installation (8m+ pipe run) | ₱7,000 – ₱15,000 | Very long pipe runs require refrigerant top-up and may affect unit efficiency. Not recommended beyond 15m. |
| Ceiling cassette — commercial installation | ₱8,000 – ₱20,000 | Requires ceiling cutout, structural brackets, and concealed piping. Labor-intensive. |
| Dedicated electrical circuit (new line) | ₱2,000 – ₱6,000 | Required for 1.5HP and above. Includes dedicated breaker, new wiring from panel to unit location. |
| Copper pipe set (per meter, 1/4" + 3/8") | ₱300 – ₱600 per meter | Material cost only. Price varies based on copper quality and pipe diameter required by unit specs. |
| Aircon bracket (outdoor unit mounting) | ₱500 – ₱2,000 | Standard L-bracket vs. wall-mounted heavy-duty bracket for typhoon-prone areas. Heavy-duty strongly recommended. |
| Relocation of existing unit | ₱2,500 – ₱7,000 | Moving an installed unit to a new room or location. Includes refrigerant recovery and recharge. |
What affects the price
- Wall material: Concrete walls cost more to cut than wood, drywall, or tile walls
- Pipe run distance: Every additional meter of copper piping adds material and labor cost
- Floor level: Higher floors require more safety equipment and time, increasing labor rates
- Electrical requirements: Units above 1HP require a dedicated 20A circuit; older homes may need full panel upgrades
- Outdoor unit placement: Ground-level installation is cheapest; rooftop or high-wall brackets add labor and materials
- Unit brand and model: Some inverter systems require specific handling during installation; authorized installers may charge premium rates
- Location: Provincial rates are generally 20–40% lower than Metro Manila rates
- Typhoon preparedness: Extra mounting hardware and waterproofing add cost but are essential in typhoon-prone provinces
Before you book
- Always use a licensed electrician for the dedicated circuit — improper wiring is a leading cause of house fires in the Philippines
- Request heavy-duty typhoon-grade brackets for the outdoor unit, especially in areas above Signal No. 1 frequency
- Do not accept installation without vacuum testing of the refrigerant lines — skipping this step causes premature compressor failure
- Get the installation done by the brand's authorized service center for your first unit to protect warranty coverage
- Ask the installer to show you the torque wrench tightening — flare connections that are hand-tightened only will leak refrigerant
- Plan the pipe route during construction if building new — hidden pipe routing saves money versus surface-mounted PVC casing later
- MERALCO requires a dedicated circuit for units 1HP and above — non-compliance can void your MERALCO insurance claims